User manual

12
Bags full of normal household dust may be disposed
of with household waste.
Insert the new paper filter as far as it will go in the
guide rails; only then can the lid be closed.
The cover cannot be closed unless a paper filter has
been inserted. Please do not use force!
Changing the microfilter
We recommend replacing the microfilter at each
fifth paper filter replacement, and at the latest when
there is a clean dust bag and the dust level indicator
is completely red with the nozzle raised.
Open the lid and fold up. Remove the used microfilter
by means of the clean hygienic tabs (figure) and
dispose of it with the household waste. Insert the new
microfilter and close the cassette.
HEPA filter
A highly effective special filter belonging to Class S.
This filter offers relief and assistance to allergy
sufferers. The HEPA filter should be replaced after
one year.
HEPA filter  further supplies available from
AEG customer service.
Motor protection filter
The motor protection filter is a permanent filter and
does not have to be replaced regularly.
Exception: the filter is damaged.
See What to do if .
Cleaning
As required, wipe the housing and the paper filter
compartment with a damp cloth. Do not use any
scourers or any solvents. Occasionally vacuum the
floor nozzle and brushheads with the crevice nozzle.
Paper filter
VAMPYR Seria 5.../COMPACT
E-Nr. 900.087.600
ET-Nr. 668.901.268
Paper filter size 28
Carrying and Storage
To make the appliance easier to store and carry, slide
the floor nozzle into the tool rail.
Parking System
For storing the suction pipe and nozzle during short
pauses in vacuuming. The bracket on the nozzle is
slid into the parking rail on the appliance.
What do I do, if ...
... it is difficult to push the nozzle
Reduce the power setting on the appliance. This will
not reduce cleaning efficiency.
... the motor thermal cut-out is activated
If the motor is overloaded, e.g. due to a full filter bag
or blocked accessory, the thermal cut-out shuts
down the motor. In this case, switch off the
appliance, unplug from the mains, and leave the
motor to cool down.
Check paper filter bag, suction tube and suction
hose; remove any blockage.
The appliance can be switched on again after
approximately 30 minutes.