Operation Manual

48
ENGLISH
WARNING:
This warns you of dangers to your health and indicates
possible injury risks.
CAUTION:
This refers to possible hazards to the machine or other
objects.
NOTE:
This highlights tips and information.
Special safety instructions
• Never stick ngers or other objects through the pro-
tection grid!
• Watch out for long hair! It can be caught in the fan
owing to the air turbulence!
• Use the appliance only with the protection grids on!
• The appliance must be assembled completely before
use!
• Select a stable base to avoid the tipping of the fan
during use!
• Do not place the device immediately next to stoves or
other sources of heat.
CAUTION:
The integrated humidier works by ultrasound. This
sound may be disturbing to pets.
General Instructions
Intended Use
This appliance can be used as a fan and/or humidier.
It is intended exclusively for this purpose and may only be
used as such. It may only be used in the manner described
in these instructions for use. The device must not be used
for commercial purposes.
Any other use of this device is considered to be contrary
to the intended use and may result in damage to materi-
als or even personal injury.
The rm ETV - Elektro-Technische Vertriebsgesellschaft
mbH does not accept any liability for damage caused as
a result of the use of this device contrary to its intended
use.
Notes on use
You can use this appliance to increase the air humidity in
a dry environment. This oers the following benets:
• Provides a healthy indoor environment and is thus
benecial to your well-being.
• Your skin does not dry out as readily.
• Static in the air is eliminated.
The appliance works best if doors and windows are kept
closed when used in mist mode.
Position
The ideal position is a non-slip, at surface.
Overview of the components
Overview
1 Hook
2 Fastening hooks
3 Propeller
4 Protection grid
5 Mounting screw M2,5*8mm with nut
6 Switch housing
7 Stand tubes
8 Tube with tank cap
9 Water tank
10 Humidier base
11 Stand with cover
Assembly overview
12 M5*18mm screws
13 Base (Base plate)
14 Metal plate with mounting holes
15 M5 nuts
16 Cover of the stand
17 M6*10mm screws with nuts
18 Motor
19 Rear protection grid
20 Nut for rear protection grid
21 Attachment screw for propeller
22 Front protection grid
Not shown
• Remote control
• ST4*25mm screw for fastening the humidier to the
stand
• M6 nuts to fasten the motor to the stand tubes
Assembly accessory overview
Number Quantity Accessories Size
5 1 Screw M2,5*8mm
5 1 Nut M2,5
12 4 Screws M5*18mm
14 1 Metal plate
15 4 Nuts M5
17 2 Screws M6*10mm
20 1 Nut
21 1 Screw
None 1 Screw ST4*25mm
None 2 Nuts M6