Operation Manual

50
ENGLISH
21. Fit the tank cap on the bottom end of the tube onto
the water tank. The recess on the tank cap must t
into the groove on the opening to the water tank.
NOTE:
• The tank cap on the end of the tube can be
turned.
• The water tank must be tted securely to the
base so that mist cannot escape between the
water tank and the base. If necessary tighten the
lower section of the tube.
Water
• Only use distilled or boiled, cold tap water without
additives.
CAUTION:
Do not ll the water tank with water from clothes
dryers and water with additives (such as scented oils,
perfume, softeners, or other chemicals). Doing so
may damage the appliance.
• Replace the water every 3-4 days, even if it has not yet
been used.
• If the appliance has not used for long periods, remove
the water from the water tank and from the base of
the humidier.
Fill with water
• Pull the end of the tube with the tank cap out of the
water tank.
• Lift the tank from the base of the humidier and turn
it over. The lling hole is located on the bottom of the
tank.
• Turn the tank cap and ll the water up to ca. 1 centi-
meter below the rim. The tank holds around 3 litres.
• Close the cap again and place the tank back onto the
base.
• Place the end of the tube with the tank cap onto the
water tank.
NOTE:
Take note of the recess on the tank cap (see assembly
instruction, item 21).
Putting into Service
Electrical Connection
• Before inserting the plug into the socket. Make sure
that the mains voltage to be used matches that of the
device. You can find this information on the nameplate.
• Connect the device to a duly installed 230 V~ 50 Hz
protective contact socket. The indicator lamp POWER
shows that the power supply is connected.
Fitting batteries into the remote control
(Batteries not supplied)
• Open the lid of the battery compartment on the rear
of the remote control.
• Insert 2 MICRO batteries of type R03 “AAA“ 1.5 V.
• Please ensure the correct polarity. Details can be found
in the battery compartment.
• Close the battery compartment.
NOTE:
If you are not going to use the remote control for a pro-
longed period, remove the batteries in order to prevent
them from leaking.
CAUTION:
• Used batteries should not be disposed of in the do-
mestic waste. Please return all batteries to a special
collection point. Your local authority will provide you
with information on this.
• Dierent types of battery or new and used batteries
must not be used together.
Remote control range
The remote control has a range of ca. 8 meters. If this
range becomes shorter, the batteries must be changed.
• To use the remote control, point it at the sensor on the
front of the switch housing.
• Make sure there are no obstacles between the remote
control and the sensor.
• The angle of the remote control to the remote control
sensor should not exceed 30° to the right, left, up, and
down.
Use
Basic Settings
Set the blower inclination angle before starting the
device. You can adjust the inclination angle by tipping the
blower casing with both hands.
NOTE:
• The inclination angle amounts to approx. 10°.
• The tube above the switch housing must not “sag”
due to the inclination of the blower. Water which
collects in the tube prevents the formation of mist.
Operation
You can operate the appliance using the remote control as
well as the buttons on the switch housing. The functions
are identical.
NOTE:
The LED´s on the switch housing indicate the settings.