Installation guide

12
The call timer is displayed as soon as you answer a call or 15 seconds after
dialling and remains on the screen for 5 seconds after the end of the call.
It is shown in hours, minutes and seconds format (HH:MM:SS).
7.2 Make a call from direct memory keys (M1-M3)
A direct memory key, M1, M2 or M3 must be programmed with a number
before it can be used. Please see „10.2 Set the direct memory keys“ for
details.
• In idle, press and hold
M1
,
M2
or
M3
to dial the number pre-stored
into the respective key.
OR
• Press
and then press and hold
M1
,
M2
or
M3
to dial the number
pre-stored into the respective key.
>If no number is stored, you will hear a double beeps tone.
7.3 Answer a call
If the handset is not on the base or a charging cradle:
• When the phone rings, press
to answer a call, press it again to turn on
the speakerphone.
Note:
If the handset is on the base or charging cradle and if “AUTO ANS“ is set
to on: when the phone rings, pick up the handset to answer the call auto
matically, without having to press any button.
7.4 Audio boost feature
The audio boost feature allows you to amplify the handset volume.
• To turn on the audio boost feature, press
at any time during a call.
>The handset top indicator turns on.
• When the audio boost feature is activated, press
/ to increase or
decrease the handset volume within the specifi c frequency range set in
equalizer.
• To turn off the audio boost feature and return the handset volume back
to normal, press
again and the handset top indicator light turns off.
>The audio boost feature will be turned off automatically when the call
is ended.
7.5 End a call
• During a call press
to end the call.
OR