Operation Manual

1918
9.7 Registering an additional handset
Up to 4 handsets can be registered to the base to extend the phone system without
having to install extension sockets for each new phone.
Note: Handset batteries must be fully charged before registration. Hold the
handset close to the base during the registration process.
Handsets that were supplied with the base are already pre-registered.
On the base:
1. Press and hold Page for 5 seconds. The base will remain in registration mode
for 90 seconds.
On the handset:
1. If the handset us not register to a base press
OK
and then enter the 4 digit PIN
code (default = 0000) and press
OK
.
2. If the handset is already register to a base press
, scroll to « ADVANCED
SET » and press
OK
.
3. Scroll
to « REGISTER » and press
OK
.
4. Enter the 4 digit PIN code (default = 0000) and press
OK
.
A beep will be heard if the registration is successful. The handset is automatically
assigned an available handset number. Use this number when making internal calls.
Notes: If registration is not successful the first time, please repeat the process again
in case the base registration period ran out of time. If the base is not found after a
few seconds, the handset returns to standby. Try registering again.
If there are already 4 handsets registered to the base, the registration will fail. De-
register a handset before registering a new one.
9.8 De-register a handset
Use one handset to de-register another. The handset being used cannot de-register
itself.
1. Press , scroll to « ADVANCED SET » and press
OK
.
2. Scroll
to « UNREGISTER » and press
OK
.
3. Enter the 4 digit PIN code (default = 0000) and press
OK
.
4. Scroll
to highlight the handset that needs to be de-registered. A
confirmation beep will be heard and the display will return to the previous
menu.
9.9 Restore default settings
The phone can be restored to its default (original) settings. All the handsets that
are registered to the base will be retained and not deleted.