Operation Manual

16
English
GB
Never lead the workpiece to the grinding disk with your hand.
Under extreme conditions (e.g. smooth-grinding metals with the arbour
and vulcanized  bre grinding wheel), signi cant contamination can build
up on the inside of the angle grinder. For safety reasons, in such conditions
the inside should be cleaned thoroughly of metal deposits and a residual
current device (FI, RCD, PRCD) must be connected in series. If the residual
current device responds, the machine must be sent for repair.
For accessories intended to be  tted with threaded hole wheel,
ensure that the thread in the wheel is long enough to accept the
spindle length.
When cutting-o material, use the closed safety guard from the
accessories range.
SPECIFIED CONDITIONS OF USE
The angle grinder may be used for cutting, grinding, sanding and
wire brushing a wide range of materials, such as metal or stone. If
you have any doubts, please refer to the instructions supplied by the
accessory manufacturer.
Do not use this product in any other way as stated for normal use.
MAINS CONNECTION
Connect only to single-phase AC current and only to the system
voltage indicated on the rating plate. It is also possible to connect
to sockets without an earthing contact as the design conforms to
safety class II.
ECDECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is in
conformity with the following standards or standardized documents.
EN 60745, EN 55014-1, EN 55014-2, EN 61000-3-2, EN 61000-3-3, in
accordance with the regulations 2006/42/EC, 2004/108/EC
Rainer Kumpf
Manager Product Development
Authorized to compile the technical  le
Winnenden, 2010-12-09
MAINTENANCE
The ventilation slots of the machine must be kept clear at all times.
Do not let any metal parts enter the airing slots - danger of short
circuit!
Use only AEG accessories and spare parts. Should components need to
be replaced which have not been described, please contact one of our
AEG service agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state
the Article No. as well as the machine type printed on the label
and order the drawing at your local service agents or directly at:
AEG Elektrowerkzeuge, Max-Eyth-Straße10, D-71364Winnenden,
Germany.
ELECTRONICS WS 12125 XE
The built-in electronic will keep a constant speed even under
increased load.
Should the machine be overloaded, the rotational speed is being
reduced to standstill.
SYMBOLS
Please read the instructions carefully before
starting the machine.
CAUTION! WARNING! DANGER!
Always wear goggles when using the machine.
Always disconnect the plug from the socket before
carrying out any work on the machine.
Accessory - Not included in standard equipment,
available as an accessory.
Do not dispose of electric tools together with
household waste material! In observance of
European Directive 2002/96/EC on waste electrical
and electronic equipment and its implementation
in accordance with national law, electric tools that
have reached the end of their life must be collected
separately and returned to an environmentally
compatible recycling facility.