Operation Manual

24
1.5 Important Note
Keep these instructions in a safe place, pass on to the new owner in case of a change of ownership.
Make them available to the specialist in the case of repair work.
What to do when . . . ?
For the User
Check whether . . .
. . . the selector knob is set to
position 3.
. . . the corresponding fuses in
your fuse box are defective or
the FI switch has switched off.
Eliminate the cause!
If the following day the
storage heaters have still not
heated up, call a specialist.
For the specialist
Check whether . . .
. . . the control of the heating
element contactor is OK.
. . . there is a voltage at terminals
L1/L2/L3.
. . . whether the safety temperature
limiter (F1) has triggered.
• the storage heater
does not get hot
• the storage heater
housing should get
extraordinarily
hot even in mild
weather
CLICK
L
HLH
L
E
N
N
N
N
N
L
LSH
TALELHLH
L
E
N
N
N
N
N
L
L-SH
For the User and the Fitter
Check whether . . .
. . . the control signal Z1 of the
charging control unit is
applied at terminal A1/Z1 in the
storage heater.
"CLIC"
03 GB WSP_1510S.p65 27.01.2004, 16:3224