User manual

EN - INSTALLATION

FITTING THE HOOD BODY

• Open the top suction panel and fasten it to the

hood body on the left using the pin, so that it

does not close again.

• Unlock the lower suction panel by removing the

fixing pin on the left, and open it.

• Remove the Metal grease filters using the handles

provided.

• Adjust the two screws Vr, in the brackets 11a, so

that they are at the start of their travel.

• Hook the hood body to the two brackets 11a.

• From the inside of the hood body, turn screws Vr

to level the hood body itself.

• Fasten the safety screws 11.

• Close the suction panels.

CONNECTIONS

DUCTED VERSION AIR EXHAUST SYSTEM

When installing the ducted version, connect the hood

to the chimney using either a flexible or rigid pipe

ø 150 or 120mm, the choice of which is left to the

installer.

To install a ø 150 pipe

• To install the dumper 10

• Fix the pipe in position using sufficient pipe clamps

(not supplied).

To install a ø 120 pipe

• To install a ø 120 mm air exhaust connection,

insert the reducer flange 9 on the dumper 10.

• Fix the pipe in position using sufficient pipe clamps

(not supplied).

• Remove any activated charcoal filters.

RECIRCULATION VERSION AIR OUTLET

• Screw the filter cover onto the air outlet, using

four screws 12c (2.9 x 12.5).

• Fix the directional grille 8 on the recirculation air

outlet using the 2 screws 12d (2,9 x 9,5) pro-

vided.

ø 120

ø 150

11a

12c

12d