User manual

5
ENGLISH
5. CONTROLS
The hood is fi tted with a control panel with
aspiration speed selection control and a
light switch to control cooking area lights.
Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking
and to leave in operation during cooking
and for another 15 minutes approximately
after terminating cooking.
The control switches are located on the
hood’s front panel:
1A
1B
1C
1D
1E
A. OFF – ON push button
Press once or more to obtain the
function desired:
ON: the hood switches on to the last
speed selected.
OFF: all the functions are switched off
except the illumination.
B. Speed selection push button (extraction
power).
Press this push button once or more
to select the most suitable extraction
speed (power) (1-2-3).
C. The display shows the extraction
power selected, signalling the
saturation of the fi lters F.
D. Intensive speed on/off. The Intensive
speed runs for 5 minutes:
If the hood is on when the Intensive
speed is activated, the hood reverts to
previous speed after 5 minutes.
If the hood is off when the Intensive
speed is activated, the hood will be
turned off after 5 minutes.
To interrupt the Intensive speed, press
button A or B.
E. Light ON/OFF
Should the hood or the controls fail to
operate: disconnect the power supply for at
least 5 seconds, then turn the hood back
on again.
Grease and charcoal fi lter maintenance
indicator
This hood is fi tted with a device that
indicates when maintenace of fi lters should
be done.
If the hood is to be used with a charcoal
fi lter, the saturation
indicator light must be enabled as follows:
Set the hood in “OFF”.
Pressing keys B and D simultaneously for
three seconds, LED F lights up and begins
to fl ash the 1st speed led. After 1 second
the 2nd speed led also fl ashes and the
system emits a sound signal (-Beep-) to
indicate setting taking place.
To remove the charcoal fi lter signal press
push buttons B and D simultaneously for 3
seconds. LED F lights up and begins to
fl ash the 1st speed led (grease fi lter) and
the 2nd speed led. After 1 second, only
the 1st speed led continues to fl ash. The
system emits a sound signal (-Beep-) to
indicate setting taking place.
Grease fi lter LED
The 1st speed led (+ led F) fl ashes, when it
is time to clean the grease fi
lter.
Always comply with the maintenance
instructions for the grease fi lter.
Charcoal fi lter LED
The 2nd speed led (+ led F) fl ashes,
when the charcoal fi lter needs to be
cleaned or replaced.
Resetting the saturation indicator
After cleaning or replacing the fi lters, press
button A for 3 seconds until the 1st speed
led or the second speed led stops fl ashing.
The F LED also turns off.