User's Manual

LOCATION PARAMETERS DEFAULT FUNCTIONS & VALUES

0 1 Master Code 0 0 0 0 Factory Set, Not a default value *

0 2 Super User Codes Nil ----- User Program Required

0 3 Common User Code 1 Nil ----- User Program Required

0 4 Common User Code 2 Nil ----- User Program Required

1 0 User Codes & Cards for O/P 1 Nil ----- User Program Required

2 0 User Codes & Cards for O/P 2 Nil ----- User Program Required

4 0 Visitor Codes Nil ----- User Program Required

4 1 Duress Code for O/P 1 Nil ----- User Program Required

4 2 Duress Code for O/P 2 Nil ----- User Program Required

5 1 O/P Mode of The O/P 1 Time = 5 Sec, Momentary

5 2 O/P Mode of The O/P 2 Time = 5 Sec, Momentary

5 6 Start & Stop Time Nil ----- User Program Required

5 5 System Real-Time-Clock Nil ----- User Program Required

9 3 Wiegand Output Format Code = 1, 26-Bit

9 4 Operation Modes Code = 0 ,Keypad Mode

6 0 Personal Safety & Lock-out Code = 1, 10 False Code/Card Lock-out 60 Sec

7 0 User Code Entry Mode Code = 2, Manual Entry Mode

7 1

7 2 O/P Operation Announcer

7 3 Status LED Standby Flashing ON-

OFF

Code = 1, Flashing Enabled

8 0 Door Forced Open Warning & Timing Code = 0, Warning Disabled

8 1 Door Propped-up Warning & Delay Code = 0, Warning Disabled

9 0 Egress Delay & Warning

9 1 Door Opening Alarm & Timer Code = 0, Alarm O/P Disabled

9 2

Wiegand Output Mode

Code = 1, Disabled

Code = 1, Pacifier Tone ON

Code = 1 Sec, Notification Beep ON

Pacifier Tones ON-OFF Selection

Code 1 = 1, Momentary Contact without Warning

Code 2 = 0, Instant, No Delay

THE DEFAULT VALUES AFTER REFRESHING

NOTE:

The DAP Code 2 8 2 8 and the Refreshing Code 9 9 9 9 are fixed in the operating system program.

It can not be changed in any ways.