User's Manual

SUPER USER CODE

3) Pause The Scheduled Daily Inhibition for Output 1 (Temporarily Disable The Inhibition)

The scheduled inhibition can be programmed and applied to Output 1 with daily start and stop times.

It can be stopped temporarily if required; such as the staff work overtime after office hours going

into the inhibition period. This function Starts / Stops in toggle with the following code entry. It can

be done before or during the inhibition period.

---------- Door Lock Operation Resumes, Start / Stop in Toggle

NOTE :

•

The “INHIBIT” LED (Red) is ON in inhibition and turns to Flashing while pause is into effect.

•

See Programming Locations 55 & 56 for more information Daily Inhibition.

4) Inhibit All The User Codes & EM Cards for Output 1 (Disable Access Control Manually)

To enhance the security of the access control keypad, the owner can stop the keypad after office hour

or while the house is nobody inside. Once the Output 1 (for door lock control) is inhibited, all the User

Codes / Cards for it become invalid and those people holding the User Code or Card are refused. This

function Starts / Stops in toggle with the following code entry.

------ Door Lock Operation Inhibited, Start / Stop in Toggle

NOTE :

•

The door is locked during Output 1 inhibited and the “INHIBIT” LED (Red) is ON.

•

Inhibition applies to all User Codes and EM Cards for Output 1 only. Output 2 is not affected.

SUPER USER CODE

REMARK :

While SUPER USER CODE





is in operation to hold the door lock open, the functions that

rely on the door sensor (such as a magnetic contact) and the User Codes for output 1 are all

temporarily suspended until SUPER USER CODE





is keyed in again to release the door hold

function.

The following are the temporarily suspended functions:

 Door Auto-relock

 Door Forced Open Warning (at Location 80)

 Door Propped-up Warning (at Location 81)

 Door Opening Alarm (at Location 91)

 Dual Keypad Inter-lock Operation

 All User Codes Including Super User Code for Output 1

 Duress Output Actuated by The Duress Code for Output 1