User's Manual

(F) OUTPUT 2

( i ) Shunting an N.C. Zone

Use the Normally Open (N.O.) output contact to shunt a Normally Closed (N.C.) protection zone of an

alarm system.

Set output contact to Start / Stop Mode (Programming Option 52, Output Mode=0).

Use the (N.O.) or (N.C.) output contact to make arm-disarm control of an alarm system.

Consult your alarm control panel manual for the appropriate output contact for arm-disarm control.

Usually set output 2 to Momentary mode (Programming Option 521, Location 52, Output Mode=1) for

multi station systems and Start / Stop mode (Programming Option 520, Location 52, Output Mode=0)

for single station systems.

( ii ) Alarm System Arm-Disarm Control

N.O.

N.O. or N.C.