User's Manual





OPERATION MODES (Location 94)

The keypad is programmable for keypad mode to work stand-alone for door control directly or for

server mode to work with a split-decoder for high security access control.

LOCATION OPERATION MODES VALIDATION

(1) LOCATION

Key in Location

(2) OPERATION MODES

– Keypad Mode (Default)

Keypad Mode sets the keypad for stand-alone operation to provide its available functions. It is

compatible with the auxiliary readers/keypads for multi-station expansion.

– Server Mode

Server Mode sets the keypad to compatible with both the decoder for split-decoded operation and

the auxiliary readers/keypads for multi-station expansion. A split decoded keypad system uses the

keypad(s) for human interface outside and the internal decoder for door lock control to prevent

sabotage.

(3) VALIDATION

Press key once. Two-beep confirms the entry



 

(3)(2)

(1)

CLOSE PROGRAMMING MODE ( * * )

Always close programming mode with * * to set system back to normal Operation after

programming.

The button is equiv

alent to the button in the keypad with bell button.

VALIDATION

------------------------------- System is back to normal operation mode





4) Inhibit All The User Codes & EM Cards for Output 1 (Disable Access Control Manually)

o enhance the security of the access control keypad, the owner can stop the keypad after office hour

or while the house is nobody inside. Once the Output 1 (for door lock control) is inhibited, all the User

Codes / Cards for it become invalid and those people holding the User Code or Card are refused. This

function Starts / Stops in toggle with the following code entry.

------ Door Lock Operation Inhibited, Start / Stop in Toggle

NOTE :

•

e door

is locked during Output 1 inhibited and the “INHIBIT” LED (Red) is ON.

• Inhibition applies to all User Codes and EM Cards for Output 1 only. Output 2 is not affected.

SUPER USER

CODE