User's Manual

Report Duress in EM Card Operation
The Duress Codes are Prime User Codes in the system. In the “EM Card + Secondary User Code”
or “EM Card + Common User Code” operation, they can be used to replace the “Secondary User
Code” or the “Common User Code” to operate the specific output and report a duress alarm event.
Programming is not required. The system has the function automatically while Duress Code exists.
EGRESS DELAY , WARNING AND ALARM (Location 90)
(1) LOCATION
Key in Location
(2) CONFIGURATIONS OF THE EGRESS WARNING AND ALARM
Key in the number to enable 1 of the 6 configurations described below:
 --- Momentary Contact Mode without Warning -- (Default)
 --- Momentary Contact Mode with Warning Beep
 --- Momentary Contact Mode with Warning Beep & Alarm
 --- Holding Contact Mode without Warning
 --- Holding Contact Mode with Warning Beep
 --- Holding Contact Mode with Warning Beep & Alarm
(3) EGRESS DELAY TIMER
 --- No Delay – (Default)
Output 1 activates instantly (the door is released instantly) when the Egress Button is pressed.
 –  --- Egress Delay Timing
Put a number of 1 to 99 into the box to enable the Egress Delay. The number is the time in second,
which starts to count when the Egress Button is pressed. Output 1 activates (the door is released)
when the delay time reaches.
CONFIGURATIONS VALIDATIONDELAY TIMELOCATION

-
 
or

-
 
Press the Button once. No warning or alarm is given during Egress Delay.
Good for silent area. The people have to wait for the door open until the delay time reaches.
Press the Button once. The system gives Warning Beeps during the Egress Delay.
Good for the place required attention. The keypad beeps during the people are waiting for the
door open.
Press the Button once. The system gives Warning Beeps and also activates its Alarm O/P during
the Egress Delay
Good for door for the authorized people only. The keypad beeps and report alarm to a security
system during the people are waiting for the door open.
This is usually an “Emergency Exit”. The door can be opened with the Keypad without triggering
of the Buzzer and Alarm Output.
Press and hold the Button. No warning or alarm is given during the Egress Delay.
Good for the silent area. The people require to press & hold the button until the delay time
reaches for the door open.
Press and hold the Button. The system gives Warning Beeps during Egress Delay.
Good for the place required attention. The keypad beeps while the button is kept pressed during
the people are waiting for the door open.
Press and hold the Button. The system gives Warning Beeps and also activates its Alarm O/P
during Egress Delay.
This is usually an “Emergency Exit”. The door can be opened with the Keypad without triggering
of the Warning and Alarm.
 
(2) (4)(3)(1)
Operation : Taking Duress Code 3 3 6 9 in Group 1 for Output 1 As Example
(a) (b) (c)
a) Read the EM card. Two-beep confirms the reading and 30 seconds waiting time is given for the
entry of Duress Code, the Amber LED keeps flashing
b) Key in the Duress Codes 3 3 6 9 for operating Output 1
c) Confirm it with the key. Output 1 activates in a normal way and the Duress Output also
activates to report Duress Event to an alarm system if connected.
NOTE: Duress Event can not be reported with EM Card alone. User can only directly use Duress
Read Card
Code to open the door and report duress event in emergency
