User's Manual

Wall Mount Instructions
( Tool Not included)
Basic tools needed for assembly (not included): Drill,
Phillips screwdriver, rubber mallet/hammer, and level.
Step1: Locate and mark where the case is to
be installed. Use a level to be sure that the
case is level and straight. Drill a ¼” pilot hole.
Step 2: Place the anchor over the hole and
firmly tap it in until it’s flush with the wall.
Step 3: Insert the screw into the anchor and set
to the depth sufficient for the case to latch on to.
Step 4: Carefully mount the display case onto
the wall and make sure the hinges sit properly
on the screws.
Note: The battery box and power on/off switch is
located on the rear side of the case. Make sure to
install the batteries and turn on the switch before
mounting on the wall.
Remote Control:
Use the remote control to change the display case LED lights.
Brightness Adjustment
16 Pre-set Colors 4 Light Modes
Power On/Off