Installation Manual

5
3. Installation of AEM
®
intake system.
a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed
to do so.
b. Install the rubber edge trim on the heat shield
as shown.
c. Install the edge trim on the heat shield as
shown.
d. Install a M6 rubber mount onto the heat shield,
secure with supplied M6 nut.
e. Insert the MAF sensor into the AEM
®
intake
pipe with the supplied M4 screws.
f. Insert the AEM
®
intake pipe through the heat
shield’s inlet hole.
g. Slide the air lter and #48 hose clamp onto the
end of the intake pipe. Slide the air lter onto the
intake pipe until the pipe hits the pipe stop.