Installation Manual

6
h. Orient the hose clamp as shown in the picture,
then tighten.
i. Install the silicone coupler and two #44 hose
clamps onto the intake pipe. Orient the hose
clamps as shown but do not completely tighten.
j. Carefully maneuver the AEM
®
intake pipe as-
sembly into position. Ensure the slotted bracket
on the intake pipe is seated on the rubber mount
stud.
k. Slide the silicone coupler onto the compressor
inlet pipe. Orient the hose clamps on the com-
pressor inlet as shown and tighten securely.
l. Secure the heat shield with the supplied M6
bolt and two factory M6 nuts removed in step 2c.
Tighten all 3 fasteners.
m. Secure the inlet pipe to the rubber mount with
the supplied fender washer and M6 nut, but do not
completely tighten.