Installation Manual

7
n. Align the intake pipe so it is centered within
the heat shield’s inlet hole. Tighten the M6 nut to
secure the rubber mount assembly.
o. Hold the intake pipe in position and tighten the
nal hose clamp on the silicone coupler.
p. Replace the headlight access cover that was
removed in step 2j.
q. Route the MAF sensor wiring harness under the
intake pipe and then secure to the MAF sensor.
Secure the MAF sensor wiring to the intake pipe’s
bracket with the tree-mount zip tie.
Factory air box system installed AEM
®
intake system installed