Installation Manual

8
AEM Air Intake System Warranty Policy
AEM
®
warrants that its intake systems will last for the life of your vehicle. AEM
®
will not honor this warranty due to me-
chanical damage (i.e. improper installation or tment), damage from misuse, accidents or ying debris. AEM
®
will not war-
rant its powder coating if the nish has been cleaned with a hydrocarbon-based solvent. The powder coating should only
be cleaned with a mild soap and water solution. Proof of purchase of both the vehicle and AEM
®
intake system is required
for redemption of a warranty claim.
This warranty is limited to the repair or replacement of the AEM
®
part. In no event shall this warranty exceed the original
purchase price of the AEM
®
part nor shall AEM
®
be responsible for special, incidental or consequential damages or cost
incurred due to the failure of this product. Warranty claims to AEM
®
must be transportation prepaid and accompanied with
dated proof of purchase. This warranty applies only to the original purchaser of product and is nontransferable. Improper
use or installation, use for racing, accident, abuse, unauthorized repairs or alterations voids this warranty. AEM
®
disclaims
any liability for consequential damages due to breach of any written or implied warranty on all products manufactured by
AEM
®
. Warranty returns will only be accepted by AEM
®
when accompanied by a valid Return Merchandise Authorization
(RMA) number. Credit for defective products will be issued pending inspection. Product must be received by AEM
®
within
30 days of the date RMA is issued.
If you have a warranty issue, please call [phone] and our customer service department will assist you. A proof of
purchase is required for all AEM
®
warranty claims.
For technical inquiries
e-mail us at
[e-mail]
or
call us at
800.992.3000
4. Reassemble Vehicle
a. Position the inlet pipes for the best tment. Be sure that the pipes or any other components do not contact any part
of the vehicle. Tighten the rubber mount (if applicable), all bolts, and hose clamps.
b. Check for proper hood clearance. Re-adjust pipes if necessary and re-tighten them.
c. Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are properly
tightened.
d. Reconnect negative battery terminal and start engine. Let the vehicle idle for 3 minutes. Perform a nal inspection
before driving the vehicle.
5. CARB Sticker Placement
a. The C.A.R.B. exemption sticker, (attached), must be visible under the hood so that an emissions inspector can see
it when the vehicle is required to be tested for emissions. California requires testing every two years, other state
may vary.
6. Service and Maintenance
a. AEM Induction Systems requires cleaning the intake system’s air lter element every 100,000 miles. When used in
dusty or off-road environments, our lters will require cleaning more often. We recommend that you visually inspect
your lter once every 25,000 miles to determine if the screen is still visible. When the screen is no longer visible
some place on the lter element, it is time to clean it. To clean, purchase our Synthetic air lter cleaner, part number
99-0624 and follow the easy instructions.
b. Use window cleaner to clean your powder coated AEM
®
intake tube.
NOTE: DO NOT USE aluminum polish on powder coated AEM
®
intake tubes.
10-478M
03/18/14
SOME INTAKE SYSTEMS ARE NOT LEGAL FOR
SALE OR USE ON ANY POLLUTION CONTROLLED
MOTOR VEHICLE IN CALIFORNIA OR STATES
ADOPTING CALIFORNIA EMISSION PROCEDURES.
See aemintakes.com for CARB status on each part for a specific vehicle