® Equipped with AEM Dryflow™ Filter No Oil Required! INSTALLATION INSTRUCTIONS PART NUMBER: 22-404 1994-2001 ACURA Integra GS-R L4-1.8L C.A.R.B. E.O. # D-670 * NOTE: Legal in California only for racing vehicles which may never be used upon a highway AEM Induction Systems 1 (800) 992-3000 WWW: http://www.aemintakes.
PARTS LIST Description Qty. Part Number Air Filter Assy. 2.75 X 5" Dry Ele. 1 21-202DK Short Pipe, Int. 94-01 GS-R 1 2-4041 Hose, Silicone 2.75x3" Blk. 1 5-275 Hose; 3/8"ID X 14"L 1 5-1014 Mount, Rubber 1" X 6mm 1 1228599 Washer, 6mm Soft Mount 1 559999 Grommet, 3/8" 1 784633 Grommet, 1/2" 1 784634 Nut, M6 Hex Serrated 1 444.460.04 Hose Clamp, 3/4" 4 4093-5 1/2" Bnd. Hose Clamp, 2.31-3.25" 2 9444 1/2" Bnd. Hose Clamp, 2.56"-3.
Read and understand these instructions BEFORE attempting to install this product. Failure to follow installation instructions and not using the provided hardware may damage the intake tube, throttle body and engine. 1. Preparing Vehicle a. b. c. d. e. Make sure vehicle is parked on level surface. Set parking brake. If engine has run in the past two hours, let it cool down. Disconnect negative battery terminal. Do not discard stock components after removal of the factory system. 2.
g. Install the air filter. ® i. Install the AEM filter onto the end of the inlet tube. Push the filter on around 2 inches over the inlet pipe and install one hose clamp to secure the filter on to the inlet pipe. Once fitment is checked, you can either push the filter on to the inlet pipe more or less depending on clearances. Tighten the hose clamp after this is done. Be sure to leave ample clearance between the filter and any surrounding components. h.
AEM Air Intake System Warranty Policy ® AEM warrants that its intake systems will last for the life of your vehicle. AEM will not honor this warranty due to mechanical damage (i.e. improper installation or fitment), damage from misuse, accidents or flying debris. AEM will not warrant its powder coating if the finish has been cleaned with a hydrocarbon-based solvent. The powder coating should only be cleaned with a mild soap and water solution.