Installation Manual

3
REMOVE
b. Remove the two nuts and two plastic rivets
that hold the plastic engine cover on. The
plastic rivets may be gently lifted with a small
screwdriver. Remove the engine cover.
Read and understand these instructions BEFORE attempting to install this product.
Failure to follow installation instructions and not using the provided hardware may
damage the intake tube, throttle body and engine.
1. Preparing Vehicle
a. Make sure vehicle is parked on level surface.
b. Set parking brake.
c. If engine has run in the past two hours, let it cool down.
d. Disconnect all negative battery terminals.
e. Do not discard stock components after removal of the factory system.
2. Removal of stock system
a. There are two vacuum switching valves (VSV), and one air flow meter that have electrical and/or vacuum
connections going to them. Be sure to label these connections before disconnecting them.
c. Disconnect the positive battery terminal.
Remove the bolt on the radiator support that
secures the battery bracket. Unhook the rod at
the rear of the battery bracket. Remove the
battery from the vehicle.
NOTE: Refer to the owner’s manual for
specific details regarding battery removal.