Installation Manual

4
d. Loosen the two 10mm hose clamps at the
throttle body and air box. Remove the stock
rubber intake hose from the engine bay.
e. Remove the air flow meter connector from
the sensor. Remove the two small screws and
remove the sensor from the air box. Use care
when removing this component, as it can be
easily damaged. Set the air flow meter aside
in a safe place.
g. Remove the other side of the large vacuum
line from the VSV mounted to the air box. Keep
both vacuum line spring clamps; they will be
reused with the AEM
®
intake system.
f. Remove the large vacuum line from the
engine side of the air box lid.