Installation Manual

d. Place the supplied VSV bracket spacer in-

line with the hole exposed in the previous step.

3. Installation of AEM

intake system.

a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until

instructed to do so.

b. Check to see that the inside of the AEM

inlet pipe and air filter are clean and free from any foreign objects

and/or obstructions.

m. Remove the stock intake air duct from the

engine bay. The duct is retained by one bolt

and one plastic rivet. Pry the center of the

plastic rivet up with a small screwdriver; the

entire rivet should pull out.

l. Remove the three bolts retaining the lower air

box. Remove the lower air box from the

vehicle.

c. Remove the forward-most M8 bolt from the

black bracket under the brake master cylinder.