Installation Manual

7
g. Use one of the supplied zip ties to secure
the upper VSV to the bracket. Make sure the
zip tie rests in the notches in the bracket to
ensure that it does not slide off.
h. Mount the MAF sensor to the adaptor on the
underside of the AEM
®
intake pipe using the
two supplied 8-32 cap screws.
f. Use the supplied M8 bolt to secure the
assembly to the bracket beneath the master
cylinder. Be sure that the spacer remains in
place. Rest the upper VSV on the bracket as
shown. The rear vacuum line may need to be
pulled back slightly to clear the bracket.
e. Using the supplied M6 bolt, mount the VSV
bracket assembly to the lower VSV from step
2k.
Thread into VSV