Installation Manual

8
i. Place the supplied silicone hose on the
throttle body. Loosely secure the hose with the
two supplied 2.75” hose clamps.
k. Install the AEM
®
intake pipe into the engine
bay with the air filter already installed. The
intake bracket should line up with the rubber
mount. Loosely secure the bracket to the
rubber mount with the supplied M6 washer and
lock nut. Refer to the diagram above for proper
rubber mount installation.
l. Install the throttle body end of the pipe into
the silicone coupler. Plug in the MAF sensor on
the back side of the pipe.
NOTE: Failure to plug the MAF sensor in
will cause the check engine light to
illuminate and the vehicle to run poorly.
j. Install the supplied rubber mount onto the
metal lower air box bracket. See diagram
below for proper rubber mount installation.
Bracket