Installation Manual

Fig. 3 Fig. 4

i. Remove the nut securing the resonator box to the inner fender. (Fig. 5)

j. Pull the wheel well liner down and towards the back of the vehicle. Locate the bracket just behind the driving

light, securing the resonator box to the underside of the passenger’s side bumper cavity. Remove the nut

and the resonator box from the vehicle. (Fig. 6)

Fig. 5 Fig. 6

3. Installation of AEM

intake system.

a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until

instructed to do so.

b. Check to see that the inside of the AEM

intake pipe and air filter are clean and free from any debris or

obstructions.

c. Install the 2.75” coupler hose onto the turbo inlet tube using a hose clamp. (Fig. 7)

d. Install the rubber mount assembly. Secure to the fender with a washer and serrated nut. Loosely attach

the washer and serrated nut to the engine bay side of the rubber mount. (Fig. 8)