Instruction Manual

ManualsBrandsAEM ManualsCar25-104BK High Volume Fuel Rail

ADVANCED ENGINE MANAGEMENT INC.

2205 126

Street, Unit A Hawthorne, CA. 90250

Phone: (310) 484-2322 Fax: (310) 484-0152

Http://www.aempower.com

Part Number: 10-282

! WARNING

HI-FLOW

FUEL

RAIL

Installation Instructions for:

Part Number 25-104

1990-1993 Honda Accord

1992-1996 Honda Prelude

1997-2000 Honda Prelude

Read and understand these instructions BEFORE attempting to install this product.

Summary of content (5 pages)

PAGE 1
HI-FLOW FUEL RAIL Installation Instructions for: Part Number 25-104 1990-1993 Honda Accord 1992-1996 Honda Prelude 1997-2000 Honda Prelude Read and understand these instructions BEFORE attempting to install this product. ! WARNING ADVANCED ENGINE MANAGEMENT INC. 2205 126TH Street, Unit A Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 Http://www.aempower.
PAGE 2
• Do not smoke while working on the fuel system. • Keep open flames or sparks away from your work area. • Be sure to relieve fuel pressure while engine is off. 1) Getting started a) Make sure vehicle is parked on a level surface. b) Set parking brake. c) Disconnect the negative cable from the negative battery terminal. d) If engine has run within the past two hours let it cool down. e) Clean the area around the fuel rail so that dirt cannot get into the engine.
PAGE 3
c) Disconnect the vacuum hose from the fuel pressure regulator. d) Place a rag or shop towel over the fuel pressure regulator. i) Remove the two 6mm retaining bolts. ii) Position the fuel pressure regulator out of the way. (1) Be careful not to loose the o-ring that goes between the fuel rail and the fuel pressure regulator. e) Loosen and remove the retainer nuts/bolts on the fuel rail, injector harness, and any other components that may be bolted to the fuel rail. f) Disconnect the fuel rail.
PAGE 4
Fig.
PAGE 5
4) Assembly of the AEM Fuel Rail Refer to the attached vehicle-specific assembly drawings for proper assembly. a) Line up the stock fuel rail with the AEM Fuel Rail. i) Lubricate the threads of the fuel inlet fitting with a light coat of engine oil. Install the fuel inlet fitting into the end, or the top, of the AEM Fuel Rail that matches the placement of the fitting in the stock fuel rail. Make sure that one of the –6 crush washers is installed under the head of the fuel inlet fitting.