Installation Manual

4
e. Loosen the (1) plastic screw and (1) plastic clip to
remove the engine side bay cover.
f. To remove the front inlet duct, remove the (1) plastic
clip and (1) bolt securing the duct in place. Slide the
scoop out of the airbox and set aside.
g. Unplug the harness from the MAF sensor and unclip
from the upper and lower airbox as shown.
h. Unhook the (4) airbox clips.
i. Disconnect the breather hose on the inlet tube. j. On the bottom of the inlet tube, disconnect the plas-
tic clip from the hose.