Installation Manual

6
3. Installation of AEM
®
Intake System
a. When installing the intake system, do not completely tighten the hose clamps or mounting hardware until instructed
to do so.
b. Mount the ETI module to the heat shield as shown
using the (2) provided plastic tree clips (8-166).
c. Install edge trim 8-3005 and 8-4105 onto the heat-
shield as shown.
d. Cut edge trim (8-4034) and t along the heat shield
edges as shown. Trim accordingly to ensure proper
tment.
e. Install the heat shield, using bolt (1-2038) to fasten
the heat shield to the inner fender. Secure the front
heat shield support to the radiator support with the
stock bolt (Removed in step 2m).
f. Connect the wire harness to the ETI module. g. Fasten silicone coupler (5-300) to the throttle body
using hose clamp (9448).