Installation Manual

j. Slide the AEM

air lter over the inlet end of the

intake pipe and fasten with the provided hose clamp

(9452).

i. Mount the MAF sensor onto the AEM

intake pipe

using the provided M4 button head bolts (1-2051).

k. Loosen hose clamp (9448) and slide over the cou-

pler installed on the throttle body inlet. Insert the AEM

intake pipe into the coupler and align the bracket to

slide in-between the washer and engine block. Tighten

the M8 bolt (1-2066), that was installed in step ‘3h’ and

tighten the hose clamp (9448) securing the intake tube

to the throttle body.

h. Loosely install M8 bolt (1-2066) and washer

(559960) into the designated threaded hole located on

the engine block.