Installation Manual

4. Reassemble Vehicle

a. Position the inlet pipes for the best fitment. Be sure that the pipes or any other components do not contact

any part of the vehicle. Tighten the rubber mount, all bolts, and hose clamps.

b. Check for proper hood clearance. Re-adjust pipes if necessary and re-tighten them.

c. Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are

properly tightened.

d. Reconnect negative battery terminals and start engine. Let the vehicle idle for 3 minutes. Perform a final

inspection before driving the vehicle.

t. Insert IAT into the air filter end and attach to air

horn.

AEM

intake system installed