User's Manual
Aeon Labs Smart Energy Switch
(Z-Wave Appliance Module w/ Energy Monitor)
Introduction:
The Aeon Labs Smart Energy Switch is a Z-Wave
appliance switch which can report wattage
energy usage or kWh energy usage to a Z-Wave
gateway. It can also be controlled by other Z-
Wave devices to turn on/off to save electricity
when appropriate.
It also is a repeater in the Z-Wave network. Acting
as a bridge for communication, it will forward Z-
Wave command messages to their destinations if
the originating controller is out of range from the
destination node.
With an unobtrusive small form factor, the Aeon
Labs Smart Energy Switch will not block other
nearby AC outlets. It is available in both matte
white and matte black colors.
By taking advantage of the Z-Wave mesh
network, commands can be routed to their
destination via intermediary “listening” Z-Wave
products. Products that are Z-Wave certified can
be used and communicate with other Z-Wave
certified devices.
Z-Wave Network Instructions:
The Aeon Labs Smart Energy Switch must be
paired (included) into a Z-Wave network before it
can receive Z-Wave commands to turn on/off
and report its energy usage. The smart energy
switch can only communicate to devices within
it’s own z-wave network.
Note: The LED on the Smart Energy Switch will blink
if it is currently not paired into a Z-Wave network.
Adding/Including/Pairing the Smart Energy
Switch into a Z-Wave Network
1. Press the button on the Aeon Labs Z-Stick to
begin the Z-Wave inclusion process.
OR
Press the button labeled “Include” on the
Aeon Labs Minimote to begin the Z-Wave
inclusion process.
Note: To include the Aeon Labs Smart Energy
Switch with other controllers, please consult
the operation manual for these controllers on
how to include Z-Wave products into an
existing network. For instructions on select
partner gateways, visit www.aeon-
labs.com/support.
2. While the Smart Energy Switch is plugged into
the outlet, press the button located between
the LED.
Troubleshooting: If the Aeon Labs Smart
Energy Switch was not successfully included
into any Z-Wave network, the LED will be
blinking. If the Aeon Labs Smart Energy
Switch was successfully included to a Z-Wave
network, the LED will either be on or off
(depending on if the switch is on or off).
Removing/Resetting the Smart Energy Switch
from your Z-Wave Network
1. Hold the button on the Aeon Labs Z-Stick to
begin the Z-Wave removal process.
OR
Press the button labeled “Remove” on the
Aeon Labs Minimote Stick to begin the Z-
Wave removal process.
Note: To include the Aeon Labs Smart Energy
Switch with other controllers, please consult
the operation manual for these controllers on
how to include Z-Wave products into an
existing network. For instructions on select
partner gateways, visit www.aeon-
labs.com/support.
2. While the Smart Energy Switch is plugged into
the outlet, press the button located between
the LED.
Troubleshooting: If the Aeon Labs Smart
Energy Switch was removed from the Z-Wave
network, the LED will be blinking. If the Aeon
Labs Smart Energy Switch was not
successfully removed from the Z-Wave
network, the LED will either be on or off
(depending on if the switch is on or off).
Turning On/Off the Smart Energy Switch
Use any of the below methods to allow power
through or cut power from the Smart Energy
Switch.