Technical data

ManualsBrandsAeon Labs ManualsDimmersMicro Smart Energy Illuminator

AEO_MSEI

Micro Smart Energy Illuminator

Firmware Version : 1.24

Quick Start

A This device is a Z-Wave Actuator.

Single click the button located near the Status Indication LED or alternatively press quickly 6 times the external switch/button

control to include or exclude the device. If the Aeon Labs Micro Illuminator is not included into any Z-Wave network, the LED will

be blinking slowly continually.

Please refer to the chapters below for detailed information about all aspects of the products usage.

Product description

The Aeon Labs Micro Illuminator is a Z-Wave light dimmer specifically used to enable Z-Wave commands and control (on/off/dim)

for existing in-wall dimmers. Additionally the device can report wattage energy usage or kWh energy usage to a Z-Wave gateway

or controller. The wireless module is powered from the mains supply and is a three-wire design which requires a neutral

connection. In the event of power failure, non-volatile memory retains all programmed information relating to the units operating

status.

Installation Guidelines

The device is a 3 wire design which requires a neutral connection. The module is powered from the main supply.

The schematics below show how to wire the actuator. The power supply and the appliance are connected by the Load, Power Input

and Neutral connectors. The 3.3 Volt and External Switch connectors are for external switching.

After the electrical installation the device has to be implemented in the Z-Wave Network.

Summary of content (5 pages)

PAGE 1
AEO_MSEI Micro Smart Energy Illuminator Firmware Version : 1.24 Quick Start A This device is a Z-Wave Actuator. Single click the button located near the Status Indication LED or alternatively press quickly 6 times the external switch/button control to include or exclude the device. If the Aeon Labs Micro Illuminator is not included into any Z-Wave network, the LED will be blinking slowly continually. Please refer to the chapters below for detailed information about all aspects of the products usage.
PAGE 2
Behavior within the Z-Wave network I On factory default the device does not belong to any Z-Wave network. The device needs to join an existing wireless network to communicate with the devices of this network. This process is called Inclusion. Devices can also leave a network. This process is called Exclusion. Both processes are initiated by the primary controller of the Z-Wave network. This controller will be turned into exclusion respective inclusion mode.
PAGE 3
Configuration Parameters Z-Wave products are supposed to work out of the box after inclusion, however certain configuration can adapt the function better to user needs or unlock further enhanced features. IMPORTANT: Controllers may only allow configuring signed values. In order to set values in the range 128 … 255 the value sent in the application shall be the desired value minus 256. For example: to set a parameter to 200 it may be needed to set a value of 200 minus 256 = minus 56.
PAGE 4
0 — 255 % (Default 10) Report type send in Reporting Group 1 (Parameter Number 101, Parameter Size 4) Defines the type of report sent for the Reporting Group 1. Value Description 2 MultiSensor Report 4 Meter Report for Watt 8 Meter Report for kWh (Default) Report Type send in Reporting Group 2 (Parameter Number 102, Parameter Size 4) Defines the type of report sent for the Reporting Group 2.
PAGE 5
Technical Data Explorer Frame Support No SDK 5.02 pl3 Device Type Slave with routing capabilities Generic Device Class Multilevel Switch Specific Device Class Multilevel Power Switch Routing Yes FLiRS No Firmware Version 1.24 5 (c) 2012 Z-Wave Europe GmbH, Goldbachstr. 13, 09337 Hohenstein-Ernstthal, Germany, www.zwaveeurope.