Installation Guide

AEON-50101
Installation Instructions
M5x16mm (x4 each)-A
M6x16mm (x4 each)-B
M8x35mm (x4 each)-C
Slider plate(x4)
Adaptor plate body(x1)
Spacer (x4)
5mm Allen Key (x1)
Adaptor Brackets(x2)
Metal washer (x8)Ø8
Socket pan head screw
M8*12mm (x4)
Metal washer (x8)Ø6
Philips head screw
M6*15mm (x4)
M/N
L
F
H
J
I
K
TV
M8x9mm (x4 each)-D
Important Notes
Component Checklist
Installation will require a minimum of two people. Under
no circumstances should this be attempted by one person.
We highly recommend this product be installed by a
qualified professional.
Please do not begin installation until you have thoroughly
read and understood these instructions.
The 40-70 Articulated Wall Mount supports flat panel
displays from 40” to 70” and supports a maximum load of
90.0 kgs (200 lbs).
Ensure the wall you plan to use will safely support four
times the combined weight of the Articulated Wall Mount
and your chosen display.
Under no circumstances should this product be mounted to
metal studs.
The manufacturer does not accept responsibility for
incorrect installation.
•
•
•
•
•
•
•
G
Socket Pan Head
Screw M8*12mm (F)
Metal Washer
8mm (H)Φ
Socket Pan Head Screw
M8*12mm (F)
Metal Washer
8mm (H)Φ
fig.4.
With the help of an assistant, carefully
lift the display and attach it to the mount
head cautiously.
Tighten the screws as shown Fig.6.
BY HAND, insert two socket pan head
screw M8*12mm(F)and metal washer 8mm (H)
into threaded holes on the adaptor panel
as shown Fig.4. Leave approximately 3/8”
of exposed thread.
Φ
fig.6
Note: If the vesa size of your TV is
200x200mm, remove two horizontal
and vertical rails and mount the
adaptor plate onto the back of the
display.
200x200mm
C.1
C.2
C.3
Tighten 3
screws
LEVEL ADJUST
If your TV is perfectly level when arm
is extended, you can skip this step.
To make horizontal level adjustments,
loosen two bolts with oval slots at the
back of arm assembly shown in Fig 7.
Make the necessary level adjust-
ments to your tv. Now tighten two
bolts to insure to maintain a perfectly
level TV.
Step 5: Cable Management Covers
Route wires from wall box
and cable management
covers. Insure cables are not
to tight to cause damage.
fig.7