Installation Manual

M5x16mm (x4 each)-A

M6x16mm (x4 each)-B

M8x35mm (x4 each)-E

Slider Plate(x4)

Mount Arm Assy(x1)

PLEASE NOTE: IMPROPER INSTALLATION WILL VOID WARRANTY.

Please do not begin installation until you have thoroughly read and understood these instructions.

Improper installation may cause serious injury and/or damage. It is recommended that a qualified

contractor install the AEON-45200 / AEON-45250 Full Motion Mount .

Make sure that the wall you plan to use will safely support four times the combined weight of the

mounted equipment, including its accessories.

The AEON-45200 / AEON-45250 Full Motion Mount supports LCD and Plasma Flat Panel Displaysl

This products suits displays with 800mm x 600mm (48”x24”) mounting hole patterns.

The manufacturer does not accept responsibility for incorrect installation.

A second person will be required to assist with several steps.

Adaptor Plate Body(x1)

Lag Bolt

8*70mm(x4)

Anchor(x4)

Spacer (x4)

5mm Allen Key (x1)

Tools Needed for Assembly

·Stud finder ("edge to edge" stud finder is recommended)

• Phillips screwdriver

• Pencil

• Hammer Drill(Concrete installation only), otherwise a standard drill

• 1/4" drill bit for wood studs, 1/2" drill bit for concrete

• 1/2" socket wrench or bit driver for wood screws

• Level

• Tape measure

Adaptor Brackets(x2)

Metal Washer (x8)Ø8

Socket Pan Head Screw

M8*12mm (x4)

Metal Washer (x8)Ø6

Philips Head Screw

M6*15mm (x4)

WARNING

from 42” to 80” and supports a maximum load of 90.8kg (150 lbs)

M/N

M8x9mm (x4 each)-D