User`s manual

BC 2000 DIGITAL
Audio Routing, Mixing and Processing System for Program Production Centres
.
ARENA DM CONTROL SURFACE
FUNCTIONAL DESCRIPTION
14
31. Monitor - Prim Phones - Sec Phones. In its normal position, its function is to
control the listening level in studio monitors and in primary and secondary headphones.
By pressing one of these buttons you can select a different signal source to be
monitored; the signal source you select will be associated with the corresponding button
among those defined in section 26. To change signal source, simply press the button;
the signal label will begin blinking. Then rotate the encoder in any direction until you find
the new signal. Press the button again to validate your selection. If the signal you
intend to select is already present in another button, the system will not allow you to
select it. The only selectable signals will be the ones that were defined in the
configuration software as available for monitoring.
32. Additional Pushbutton/indicator for sending the associated signal to monitoring in
the studio.
33. Additional Pushbutton/indicator for sending the associated signal to monitoring in
the control
34. Cue Reset. Reset pushbutton to cancel all cue signals. If there are one or more
channels with the CUE button selected, this indicator will be lighted. Pressing it will
cancel all the sends to the CUE bus that had been selected previously.
35. Cue - Monitor - Phones. In its normal position, its function is to control the listening
level in CUE loudspeakers on the DM surface, in control monitors and DM surface
headphones. By pressing Monitor or Phones you can select a different signal source to
be monitored; the signal source you select will be associated with the corresponding
button among those defined in section 29. To change signal source, simply press the
button; the signal label will begin blinking. Then turn the encoder in any direction until
you find the new signal. Press the button again to validate your selection. If the signal
you intend to select is already present in another button, the system will not allow you to
select it. The only selectable signals will be the ones that were defined in the
configuration software as available for monitoring. The CUE encoder cannot perform the
signal source selection function for monitoring. Further, only those signals in each
channel that were sent to the CUE bus can be sent to that bus, and selecting any signal
in sections 29 and 33 will in no case send the selected signal to the CUE loudspeakers
on the DM surface.
36. Control Headphones Connector.