User`s manual

BC 2000 DIGITAL
Audio Routing, Mixing and Processing System for Program Production Centres
.
ARENA DM CONTROL SURFACE
FUNCTIONAL DESCRIPTION
17
3.1.3. Dynamic Setup: Selection and configuration of dynamic and time
processing functions by channel, except equalization.
Press the dynamic Pushbutton indicator for the channel and the level and configuration
display (4) will show the different effects available for selection, their active-inactive
status (ON-OFF) and a label identifying the memory selected in each effect (Compres01
in this example). When the cursor is placed over this label, the list of presets is
accessed, as well as the modification of parameters. Use the left, right, up or down
navigation keys (5) or the encoder
(6) to make your selection and the
OK key to validate it.
The effects defined are:
• Compressor
• Noise Gate
• Delay
• Reverb
On the display, there is an additional
“EXIT” key to exit this display. You
can also exit by pressing the
“Dynamic” key on the channel. You
can go back to the normal display in
either of the two ways. You can also exit this display by pressing any other function key
for any channel, which will provide access to the respective functions in other channels.
Options configured as active are indicated with the border ON highlighted and bold.
Remember that if any of the dynamic options is active (any label at ON), the
“Dynamic” key for the channel will remain lit, and will begin to flash when it is
accessed this configuration display. This key will also remain lit when there is some
active test signal (see section 3.2.1.4).
By default, this button enables access to effects; in the special “Bus Send Mode”
working mode, it will be an access for direct routing of the signal present in each
channel to the output bus associated to this button in the configuration software. The
“Dynamic” function is not accessible in this mode through this button, but through the
information and configuration area (“Select”).
3.1.3.1. Compressor.
To enter the Compressor effect menu, select the preset that it appears by default
and press the OK navigator key (5). The list of available preset compression
effects will then be displayed:
The “CHANGE PARMs” option
is used to change the
associated process
parameters. “PRESET LIST”
provides access to the
complete list of preset effects,
from which a new effect can be
loaded or changes made to a
selected effect can be saved.
For the other effects, a similar
list will also be displayed with
both selection options