User`s manual

BC 2000 DIGITAL
Audio Routing, Mixing and Processing System for Program Production Centres
.
ARENA DM CONTROL SURFACE
FUNCTIONAL DESCRIPTION
43
3.2.6.2. Time and date change.
It is possible to adjust the time and date of the system, following the procedure
described in the previous section. By a rotating encoder (21) placed on the right of the
display, the highlighted values are modified. Pressing the encoder accepts the changes
and skips to the following parameter which will be highlighted. Months, days and years
can be modified inside the “DATE SET” menu, and hours, minutes and seconds, in the
“TIME SET” menu.
To exit either screen without changing the date or time, press “CANCEL“. Press “OK“ to
accept the changes and exit the screen. Pressing either “OK“ or “CANCEL“ will lead you
to the main “System Setup“ screen.
3.2.6.3. Information about Firmware versions.
The following screen shows the information corresponding to the different firmware
versions installed in the different available consoles. The information available is, for
DM console (“CONSOLE 0”), the firmware versions of Rabbit (“Communication
controller”), DSP (“Audio Processor”), microcontroller (“Mixer Controller”) y FPGA
(“Programable Logic"). “Controller” firmware version (“Frame”) is also shown. For D10
consoles (“CONSOLE 1” and the following) microcontroller and FPGA versions are
shown.
It is not possible to modify any of the parameters in this screen, they are just used to
acquire information about the firmware installed in the system.