User`s manual

EAGLE

Multi-Standard Dual-Channel Digital Audio Codec

4.10. Loop

The EAGLE audio codec has a test mode that allows the correct operation of the equipment to

be independently verified in loop mode, checking the encoding and decoding mechanisms if

there are transmission problems.

When this facility is activated, the audio codec loops audio signal in the way that incoming audio

signal from the XLR input connectors appears in XLR output connectors as Feedback, and

audio received from the ISDN or V.35 is sent back to the ISDN.

This selection is done in the SETUP section (1) (9).

- On the main screen, press NO (red) to access the SETUP menu.

- With the cursor arrows, go to the LOOP option and press OK.

- With the cursor arrows Select ON to activate the loop or OFF for normal operation.

4.11. Multiplex

When we have two 64k calls connected, they can be multiplexed, i.e., intercommunication

between them can take place. For this function to occur in all possible directions, both channels

need to be ON AIR. This scenario can also possible: one channel is ON AIR, the other on

WAIT mode, and Multiplex is pressed; here, the channel on WAIT mode can listen to the

program or the orders, but cannot participate.

 When multiplex option is activated, input 1 and output 1 is the same for both channels.

LOOP

OFF