User`s manual

AEQ FORUM
Digital audio mixer for broadcast applications
54
The associated buttons functions are the following ones:
o “Read”: allows you to read the configuration currently active in the AEQ
FORUM mixer and download it in the Forum Setup application.
IMPORTANT NOTE: the active configuration at that moment in the application
is overwrited and get lost (unless you previously save it by means of “Export”
option).
o “Send Configuration”: allows you to send the currently selected configuration
to the AEQ FORUM mixing console, thus becoming the valid configuration in
operation. The audio will be interrupted a few seconds while the new
configuration is being activated. During the sending, a bar shows the process. If
the process is properly done, the message “Send Configuration: OK” is
displayed.
o “Reset”: replaces the currently active configuration on the AEQ FORUM mixing
console with the configuration stored in the first memory or snapshot defined
(please refer to section 4.3.5 of this manual). It is equivalent to “LOAD” that first
snapshot from “MEMORY” menu of the console (see section 3.3). The audio
will be interrupted a few seconds while the new configuration is being loaded.
o “AOIP”: allows you to active at physical level the AoIP (audio over IP) function.
When you press the associated button, a window will appear allowing you to
configure the maximum number of channels that could be activated: 32 (1 FR14
module) or 64 (2 FR14 modules):
o “Licenses”: allows you to activate the MADI link and/or the “Forum Virtual” and
“Forum Screen” applications functionality (these two last are not available yet).
For any of the 3 options, you must purchase a user license.
When you press the padlock associated to any of the 3 options, a window will
appear allowing you to introduce the key associated to the corresponding
functionality.
For MADI functionality: