User`s manual

AEQ FORUM

Digital audio mixer for broadcast applications

For Eagle audio-codec, the available options are:

• “Ring”: allows you to select the GPI where the incoming call signal provided by the

codec is wired. The key starts to blink when there is an incoming call. This function can

be combined in the same key with any of the following four functions.

• “Wait GPI”: selects and configures the physical GPI input associated to “WAIT”

function. The key turns on when WAIT mode (call on hold) is activated manually in the

audio-codec.

• “Wait GPO”: selects and configures the physical GPO output associated to “WAIT”

function. The key turns on when activated and puts the call on hold (WAIT mode).

• “On Air GPI”: selects and configures the physical GPI input associated to “ON AIR”

function. The key turns on when ON AIR mode (call on the air) is activated manually in

the audio-codec.

• “On Air GPO”: selects and configures the physical GPO output associated to “ON AIR”

function. The key turns on when activated and puts the call on the air (ON AIR mode).

• “Line”: for dual line codecs such as Eagle and Phoenix Studio, this identifies the

integrated line 1 and line 2, to assign the different GPIs and GPOs for remote control.

• “OK”: allows you to accept the created or edited configuration.

• “Cancel”: allows you to reject the created or edited configuration. No change you may

have made is saved.

IMPORTANT NOTE: The pairs of functions “Wait GPI”-“Wait GPO” and “On Air GPI”-“On Air

GPO” are exclusive between them (a programmable key can have only one of the two pairs

associated).

For Codecs it is usual to program at least two programmable keys per channel: one to share

“Ring”, “Wait GPI” and “Wait GPO” functions and another one to share “On Air GPI” and “On Air

GPO” functions. The following screens show an example of programmable keys configuration

for remote control of an AEQ EAGLE audio-codec.