User`s manual

AEQ FORUM - DIGITAL AUDIO MIXER FOR BROADCAST APPLICATIONS
25
The speaker output for the control is called MONITOR and within the CONTROL ROOM section
on the rear panel of the equipment.
The speaker output for the studio is called MONITOR and within the STUDIO ROOM section on
rear panel of the equipment.
In order to simplify the installation phase, AEQ offers a prefabricated wiring kit specifically for
monitoring outputs: CAB FR MON, female DB9 connector soldered to 4 metres of cable open-
end termination for two monitor outputs. More information in section 2.2.4 of this manual.DB9
male connector
Monitoring outputs control/studio (SUB-D male 9-pin).
1 GND
6 OUT L+
2 OUT L-
7 Not connected
3 Not connected
8 Not connected
4 GND
9 OUT R+
5 OUT R-
On request, this wiring kit can be supplied with connectors explicitly specified by the customer.
For more information please refer to AEQ sales department or authorised distributors.
2.2.2.5. Control and Studio Headphones
AEQ FORUM includes studio and control headphone outputs on asymmetric connection,¼ "(6,3
mm) Phone Jack Connectors.
The Control headphone output is identified as PHONES in the CONTROL ROOM section on
the rear panel of the equipment.
The Studio headphone output is identified as PHONES in the STUDIO ROOM section on the
rear panel of the equipment.
Name Position Number
L (Left Signal) Tip 1 R (Right Signal) Ring 2 GND (Ground) Sleeve
3 ¼ "(6,3 mm) Phone Jack Connector - TRS Pin-out