User`s manual

AEQ FORUM - DIGITAL AUDIO MIXER FOR BROADCAST APPLICATIONS
40
3.4.2. SETUP Menu
Through the IPSET option in a contextual key, this menu enables you to display the IP
configuration associated with the two Ethernet ports available on the back panel of the
equipment (see section XX of this manual) in the form of an IP address (IP1 or IP2), subnet
mask (MK1 or MK2) and gateway (GW1 or GW2). Only Level 3 users are permitted to modify
these values.
As in many other AEQ FORUM console sub-menus, the icon in the upper left-hand corner
indicates that browsing and configuration (in the cases and fields where this is possible) are
performed by using the associated rotary encoders.
SETUP menu screen
From left to right, the three rotary encoders are associated with IP, MK and GW respectively.
At all times, a flashing cursor indicates the digit that is subject to change at that moment by
turning the associated encoder. Pressing the encoder will validate any change you may have
made. This process is repeated from left to right until the IP address is complete.
The ETH/LAN contextual key allows you to alternate the on-screen presentation and, therefore,
to edit (if your active user level is 3) the IP configuration parameters associated with the two
network ports available on the rear panel of the unit: LAN and ETHERNET.
3.4.3. SELECT Menu
This menu enables you to perform advanced configuration operations on audio inputs / outputs,
processes and the internal routing of all of the signals present in the console.
SELECT menu screen
ETHERNET LAN