User`s manual

AEQ FORUM - DIGITAL AUDIO MIXER FOR BROADCAST APPLICATIONS
7
AEQ FORUM Control Surface - Channel module
Located in the upper part of the channel are 4 routing keys - PROGRAM, AUDITION, AUX1 and
AUX 2, and a SELECT button to assign the channel to advanced settings common control
(gain, dynamics, EQ and balance).
Beneath this section, an OLED display shows channel name and status for balance or pan.
Immediately under the display is located the Pre-listen button CUE, and 4 LED status indicators
that alerts with regards to the activation of equalization (EQ), dynamics (DYN), balance (BAL)
and gain (GAIN). Also in this section, a luminous label indicating that the channel is activated
and is sending signal to any of the output buses - “ON AIR”.
By pressing the SELECT button the advanced configuration functions are enabled. These
configurations are accomplished within the integrated multifunction display in the control and
monitoring section at the far right of the control surface. Its operation is based on rotary encoder
and graphical menus and short-cut function keys, depending on the information shown on
screen.
Multifunction display with 4 keys and 3 contextual rotary encoders associated
Among the general functions are the instant activation and adjustment of audio effects: EQ,
filters, limiters, etc., Configuration and memory management, disconnection of effects applied,
clock, timer and stopwatch for timing control , phase change, inserting of test signals.. etc . For
more information see chapter 3.-Description of the internal menu of this manual.
The Channel module is completed with plastic conductive sliding faders and the Channel ON
and OFF buttons.