User`s manual

AEQ FORUM - DIGITAL AUDIO MIXER FOR BROADCAST APPLICATIONS

The GENERAL tab of the SALVO configuration is identical to the way a GENERAL function is

assigned to a programmable key and as described in section 4.3.2.2 and allows you to

configure the operational sequence of the programmable key and its relationship with the

system GPI´s and GPO´s. This way it is possible to execute a SALVO either by pressing the

programmable key or by the remote activation of the programmable key through GPI.

The SALVO tab includes specific functions, including a list of actions for each of the cross-

points controlled by the SALVO and the order of execution (first-up, last-down). There are three

buttons below the list enabling you to configure the list of actions:

INSERT, this simple menu allows you to insert the activation or deactivation of a cross-point in

the list of actions:

• STATUS, OFF or ON

• Off: When the programmable key is idle or OFF the SALVO is executed when

the programmable key is activated.

• On: When the programmable key is active or ON the SALVO is executed when

the programmable key is deactivated.

• ORDER, to set the position of this action in the general list of actions.

• INPUT, allows you to select the input channel or internal summing bus.

• OUTPUT, to select an output channel or internal summing bus.

• ACTION, choose between CONNECT and DISCONNECT

INSERT or MODIFY, sub-menu to add or modify actions by a SALVO

• MODIFY modifies a preconfigured action. The options on this screen are identical to

those described for INSERT.

• DELETE, to delete an action in the general list of actions. Confirmation to delete is

requested.

4.3.2.4. Configuring the programmable keys as “CODEC”

Configuring the programmable keys as “CODEC” enables you to assign functions associated

with remote control of peripheral communications equipment (such as audio-codecs) through

GPIs and GPOs.

Icon Programmable key with CODEC function assigned

The “Key Configuration” sub-menu for the PROGRAMMABLE KEYS will appear in the lower

part of the screen when you select “CODEC” as the associated function;

Device - there is a list of pre-programmed devices in the “CODEC” function: