User`s manual

AEQ FORUM - DIGITAL AUDIO MIXER FOR BROADCAST APPLICATIONS

Advanced settings menu snapshot memories

The options under the advanced settings menu memory snapshots, described from left to right

and top to bottom:

• LABEL, alphanumeric label for the snapshot memory.

• Faders, twelve drop-down menus allow you to assign an audio channel that

corresponds to one of the physical faders of the AEQ FORUM mixing console. The

faders are numbered from left to right, 1 through 12.

• STUDIO, you can set studio monitors to be active or inactive by default and following

the status of the physical keys available for this purpose (Master 1, Master 2, Cue and

Sel).

• SEL Input and Output, selects a combination or a single input or output to be

present for monitoring at the key “Sel”.

• CONTROL, you can set control monitors to be active or inactive by default and following

the status of the physical keys available for this purpose (Master 1, Master 2, Cue and

Sel).

• SEL Input and Output, selects a combination or a single input or output to be

present for monitoring at the key “Sel”.

• TALKBACK MIC configures the operation of the microphone input present in the

common I/O section at the rear panel of the AEQ FORUM.

• ORDERS, set the microphone to act as a orders microphone input for the Studio

and return for any open communication line. This is a typical configuration for the

AEQ FORUM when installed in a Studio – Control configuration.

• SELF-CONTROL, set the microphone to act as a microphone input in a self-

control configuration. This is typically the configuration adopted when the Studio

and Control areas of the radio station are in the same room or physical space, i.e.

the host of the radio program is also the operator of the mixing console.

• CONFIGURE INPUTS, OUTPUTS AND MIXERS, such as quick access button for the

section advanced settings for the audio inputs, outputs and internal mixer buses ,

presented in three consecutive columns.