Instruction Manual

AM Series Cascade Sequencer
INSTALLATION AND OPERATION MANUAL
2.2 Cascade Status Button
By pressing the Cascade Status button (Figure 2-1), the lower half of the display will change to
show the status of the cascade boilers (Figure 2-2). The designated number for each boiler in
the cascade system will be displayed, such as 1, 2, 3, 4, etc., up to 8. If there is a request for
heating for any heater, a flame icon will appear under that heater’s number. The absence of a
flame icon under the number represents a heater in standby mode.
The Cascade Status display shown in Figure 2-2 indicates there are three heaters in the
cascade, with numbers 1 and 2 calling for heat, and number 3 in standby mode.
Figure 2-2: Cascade Status Display (When Cascade Button Pressed)
2.3 Submenu Navigation, and Parameter Settings
The sub-menu may be accessed, navigated, and parameters changed as instructed below.
Submenu Navigation and Parameter Settings
1. Press and hold the Home button (Figure 2-1) for eight (8) seconds, then release the button
to display the Sub menu.
2. Once the Sub menu is displayed (Figure 2-3), use the Up or Down buttons (Figure 2-1) to
scroll through the list of parameters. A dot appears to the left of the parameter to indicate it
is selected.
Figure 2-3: Sub Menu - Selecting the Parameter to Change
3. When the desired parameter is displayed, press the Ok button. The dot will then move to
the left of the parameter setting (Figure 2-4), which begins to blink, indicating it may be
adjusted.
Figure 2-4: Sub Menu – Changing the Parameter Setting
Flame Icon
Indicates a
Request for Heat
Number
Indicating
Cascade
Heater
No Flame Icon Indicates
Heater is in Standby Mode
Dot indicating
selected
parameter
Dot indicating
parameter setting may
be changed
(Setting also blinks)
OMM-0101_0A AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 Page 21 of 26
GF-146-CS Ph.: 800-526-0288 PRI - 11/25/14