Operation Manual

Atmos Pro/Aeris 300G

• Carefully insert the battery hatch into the housing and turn it slowly

clockwise by hand to ensure correct threading. Turn until snug, then ap-

ply a coin and tighten until secure, so the outer surface of the battery

hatch is flush with the outer surface of the housing.

INSPECTION

• Activate the unit and watch carefully as it performs a full diagnostic and

battery check and enters Surface Mode.

• Observe the LCD display to ensure it is consistently clear and sharp in

contrast throughout the screen.

• If any portions of the display are missing or appear dim, or if a Low Bat-

tery condition is indicated, return the unit to your Authorized Aeris

Dealer for a complete inspection before attempting to use it.

RETURNING THE MODULE TO BOOT

ATMOS PRO

• If previously removed, replace the rubber spacer into the boot (wrist or

hose mount type).

• Orient the module over the opening in the boot, and dip the bottom edge

into it while pressing the top edge with the palm of your hand. Stop

pressing when the bottom edge of the module has just entered the boot.

Responsible