COOLMAX SRX HV User Manual

USER MANUAL
COOLMAX SRX HV Wall Mount
Australian Energy Research Labs
AER07.004 G3 Rev 8
28
th
September 2020
23
AER07.004 REV 8
Step 6 – Adjust the setting using the UP and DOWN buttons until the desired voltage is specified
and then tap Apply.
Step 7 – Finally, save your charge profile by tapping Apply. The CoolMax will save your settings and
proceed to reset/reboot.
IMPORTANT
If you do not tap “Apply” after you have finished entering the settings, the CoolMax SRX
will not the load the new charge profile into memory and you will have to repeat the
process.
IMPORTANT
If any of the set point inputs are above the allowable system parameters, a warning
message will be displayed and the CoolMax will not allow the charge profile to be saved.
Please refer to Page 19 for information on setting the correct charge profile settings.
Battery Capacity:
Charge Rate:
1 C
10 kWh