User Manual

8
9
10
Cut to length upper spruce spar TS-02 (2 x 8 mm) and glue to ribs and main spar. Use suitable weigths to hold spar in place and leave to dry.
Glue in place aileron spar TS-28, aileron leading edge TS-29 as well as gussets TS-30 and TS-31. Insert servo tray TS-32
between ribs TS-16 and TS-17, flush with underside of ribs and against wing spar. Do not glue!
Glue end stop TS-32.1 to both ribs and glue reinforcement TS-32.2 in place on aileron.
TS-02
Slightly bevel the last 3 mm of trailing edge and aileron
sheeting to establish a good contact surface for gluing.
Then glue in place top sheeting.
Tip: Glue rear edge of sheeting with epoxy to get a
strong trailing edge which can be sanded down to fine
profile.
TS-29
TS-28
TS-30
TS-31
TS-32
TS-32.1
TS-32.2
Glue together servo frames TS-32.3 and TS-32.4 as shown, and glue to spar
and ribs. Make sure that hole for servo lead is not obstructed.
Attention: Do not glue frame to servo tray TS-32! TS-32 is
merely used to position frame correctly.
TS-32.3
TS-32.4
TS-32
Carefully sand surface of wing joiner sleeve TS-35 and insert in wing root. Insert wing joiner R-40 into sleeve and make sure it
moves freely and without binding. Then remove R-40 and glue sleeve in place with epoxy mixed with glass fibres. Repeat for
TS-35.1.
Align magnet supports TS-46 and TS-47 with corresponding holes in rib TS-08, then glue to the inside of rib TS-08.
11
Glue together wing root sheeting material TS-33
and TS-34, then glue to first two rib bays.
12
TS-33
TS-34
TS-35
TS-35.1
TS-46
TS-47